Instructions / Assembly

16
TAKING YOUR BLOOD PRESSURE READING
Proceed only after reading the previous sections of this manual.
1. To select the correct User bank, press and hold the POWER
button for 5 seconds and release. The User symbol will begin to
blink. Then press the MEMORY button to switch between User
1 & 2. Once the desired User is selected, press and hold the
POWER button until the unit powers OFF. Press the POWER
button again to turn the unit ON and begin the measurement.
2. Rest your elbow on a solid surface with your palm facing upward.
Elevate your hand so that the cuff is at the same level as
your heart, Fig. 1. Relax your left hand. Sit comfortably and don’t
cross your legs. The middle of the cuff should be at the level of
the right atrium of the heart.
3. This unit will first run a self-test, Fig. 2. If there is any residual air
in the cuff, the monitor will flash “ ” until pressure is stabilized
as shown in Fig. 4.
4. When the display appears as shown, Fig. 5, the monitor is ready.
The cuff will automatically begin to inflate.
5. Once the cuff inflates to the appropriate pressure level, the
measurement will begin.
6. The unit will begin to automatically deflate and the numbers
appearing on the display will decrease.
Measurement value
becomes lower.
Measurement value
becomes higher.
Correct measurement position
(at same height as heart).
Fig. 1
AVG
mmHg
kPa
No
(
( )
)
/
/
/
mmHg
Fig. 2
mmHg
kPa
No
M
D
mmHg
M
D
mmHg
M
D
Fig. 3
mmHg
kPa
No
M
D
mmHg
M
D
mmHg
M
D
Fig. 4
mmHg
kPa
No
M
D
mmHg
M
D
mmHg
M
D