Safety Information

Page 34 of 63 Report No.: CQASZ20210400194S
IEC 62368-1
Clause Requirement + Test Result - Remark Verdict
Q.1.1 b) Impedance limited output P
- Regulating network limited output under normal
operating and simulated single fault condition
P
Q.1.1 c) Overcurrent protective device limited output N/A
Q.1.1 d) IC current limiter complying with G.9 N/A
Q.1.2 Compliance and test method P
Q.2 Test for external circuits – paired conductor cable No such external circuits N/A
Maximum output current (A) ............................... :

Current limiting method ........................................ :

R LIMITED SHORT CIRCUIT TEST N/A
R.1 General requirements N/A
R.2 Determination of the overcurrent protective
device and circuit
N/A
R.3 Test method Supply voltage (V) and short-circuit
current (A)). ..................................................... :
N/A
S TESTS FOR RESISTANCE TO HEAT AND FIRE N/A
S.1 Flammability test for fire enclosures and fire
barrier materials of equipment where the steady
state power does not exceed 4 000 W
N/A
Samples, material ............................................... :

Wall thickness (mm) ............................................ :

Conditioning (C) ................................................. :

Test flame according to IEC 60695-11-5 with
conditions as set out
N/A
- Material not consumed completely N/A
- Material extinguishes within 30s N/A
- No burning of layer or wrapping tissue N/A
S.2 Flammability test for fire enclosure and fire barrier
integrity
N/A
Samples, material ............................................... :

Wall thickness (mm) ............................................ :

Conditioning (C) ................................................. :

Test flame according to IEC 60695-11-5 with
conditions as set out
N/A
Test specimen does not show any additional hole N/A