Safety Information

Page 30 of 63 Report No.: CQASZ20210400194S
IEC 62368-1
Clause Requirement + Test Result - Remark Verdict
H CRITERIA FOR TELEPHONE RINGING SIGNALS N/A
H.1 General N/A
H.2 Method A N/A
H.3 Method B N/A
H.3.1 Ringing signal N/A
H.3.1.1 Frequency (Hz) .................................................. :

H.3.1.2 Voltage (V) ......................................................... :

H.3.1.3 Cadence; time (s) and voltage (V) ..................... :

H.3.1.4 Single fault current (mA):..................................... :

H.3.2 Tripping device and monitoring voltage ............... : N/A
H.3.2.1 Conditions for use of a tripping device or a
monitoring voltage complied with
N/A
H.3.2.2 Tripping device N/A
H.3.2.3 Monitoring voltage (V) ......................................... :

J INSULATED WINDING WIRES FOR USE WITHOUT INTERLEAVED INSULATION P
General requirements Approved TIW used P
K SAFETY INTERLOCKS N/A
K.1 General requirements N/A
K.2 Components of safety interlock safeguard
mechanism ........................................................
(See Annex G) N/A
K.3 Inadvertent change of operating mode N/A
K.4 Interlock safeguard override N/A
K.5 Fail-safe N/A
Compliance ......................................................... : (See appended table B.4) N/A
K.6 Mechanically operated safety interlocks N/A
K.6.1 Endurance requirement N/A
K.6.2 Compliance and Test method.............................. : N/A
K.7 Interlock circuit isolation N/A
K.7.1 Separation distance for contact gaps & interlock
circuit elements (type and circuit location) ........ :
N/A
K.7.2 Overload test, Current (A) ................................... : N/A
K.7.3 Endurance test N/A
K.7.4 Electric strength test .......................................... : (See appended table 5.4.11) N/A