Safety Information

Page 28 of 63 Report No.: CQASZ20210400194S
IEC 62368-1
Clause Requirement + Test Result - Remark Verdict
G.8.3.3 Temporary overvoltage ........................................ : (See appended table B.3) N/A
G.9 Integrated Circuit (IC) Current Limiters
N/A
G.9.1 a) Manufacturer defines limit at max. 5A. No IC current limiters N/A
G.9.1 b) Limiters do not have manual operator or reset N/A
G.9.1 c) Supply source does not exceed 250 VA ............ :

G.9.1 d) IC limiter output current (max. 5A) ...................... :

G.9.1 e) Manufacturers’ defined drift ............................... :

G.9.2 Test Program 1 N/A
G.9.3 Test Program 2 N/A
G.9.4 Test Program 3 N/A
G.10 Resistors
N/A
G.10.1 General requirements No such resistors N/A
G.10.2 Resistor test N/A
G.10.3 Test for resistors serving as safeguards between
the mains and an external circuit consisting of a
coaxial cable
N/A
G.10.3.1 General requirements N/A
G.10.3.2 Voltage surge test N/A
G.10.3.3 Impulse test N/A
G.11 Capacitor and RC units
P
G.11.1 General requirements Approved Y-cap. used P
G.11.2 Conditioning of capacitors and RC units P
G.11.3 Rules for selecting capacitors P
G.12 Optocouplers
N/A
Optocouplers comply with IEC 60747-5-5:2007
Spacing or Electric Strength Test (specify option
and test results) ................................................... :
The optocoupler is used in the
equipment and complied with IEC
60747-5-5 or the requirements of
5.4 (see appended table 4.1.2).
N/A
Type test voltage V
ini
.......................................... : Considered

Routine test voltage, V
ini,b
.................................. : Considered

G.13 Printed boards
P
G.13.1 General requirements P
G.13.2 Uncoated printed boards P
G.13.3 Coated printed boards N/A
G.13.4 Insulation between conductors on the same inner
surface
N/A