Safety Information

Page 27 of 63 Report No.: CQASZ20210400194S
IEC 62368-1
Clause Requirement + Test Result - Remark Verdict
G.5.4.9 Series motors N/A
Operating voltage .............................................. :

G.6 Wire Insulation
P
G.6.1 General Approved TIW used in transformer
T1
(see Annex J)
P
G.6.2 Solvent-based enamel wiring insulation N/A
G.7 Mains supply cords
P
G.7.1 General requirements Approved mains supply cords used P
Type ..................................................................... : (See appended table 4.1.2)

Rated current (A) ................................................. : 10A

Cross-sectional area (mm
2
), (AWG) ................... : Min. 0.824mm
2

G.7.2 Compliance and test method P
G.7.3 Cord anchorages and strain relief for non-
detachable power supply cords
P
G.7.3.2 Cord strain relief P
G.7.3.2.1 Requirements 0.25mm<2mm P
Strain relief test force (N) .................................... : 30N

G.7.3.2.2 Strain relief mechanism failure P
G.7.3.2.3 Cord sheath or jacket position, distance (mm) .... : >10mm

G.7.3.2.4 Strain relief comprised of polymeric material P
G.7.4 Cord Entry .......................................................... : P
G.7.5 Non-detachable cord bend protection N/A
G.7.5.1 Requirements N/A
G.7.5.2 Mass (g) ............................................................. :

Diameter (m) ....................................................... :

Temperature (C) ................................................. :

G.7.6 Supply wiring space N/A
G.7.6.2 Stranded wire N/A
G.7.6.2.1 Test with 8 mm strand N/A
G.8 Var istors
N/A
G.8.1 General requirements Approved varistor used.(See table
4.1.2)
N/A
G.8.2 Safeguard against shock N/A
G.8.3 Safeguard against fire N/A
G.8.3.2 Varistor overload test ........................................... : (See appended table B.3) N/A