Safety Information

Page 11 of 63 Report No.: CQASZ20210400194S
IEC 62368-1
Clause Requirement + Test Result - Remark Verdict
5.2.2.2 Steady-state voltage and current ......................... : See appended table 5.2) P
5.2.2.3 Capacitance limits ................................................ : (See appended table 5.2) N/A
5.2.2.4 Single pulse limits................................................. : (See appended table 5.2) N/A
5.2.2.5 Limits for repetitive pulses ................................... : (See appended table 5.2) N/A
5.2.2.6 Ringing signals ................................................... : (See Annex H) N/A
5.2.2.7 Audio signals ...................................................... : (See Clause E.1) N/A
5.3 Protection against electrical energy sources P
5.3.1 General Requirements for accessible parts to
ordinary, instructed and skilled persons
P
5.3.2.1 Accessibility to electrical energy sources and
safeguards
P
5.3.2.2 Contact requirements P
a) Test with test probe from Annex V ................... : P
b) Electric strength test potential (V) ................... : P
c) Air gap (mm) ................................................... : P
5.3.2.4 Terminals for connecting stripped wire N/A
5.4 Insulation materials and requirements P
5.4.1.2 Properties of insulating material P
5.4.1.3 Humidity conditioning ........................................ : No hygroscopic insulating material
used
P
5.4.1.4 Maximum operating temperature for insulating
materials ............................................................. :
(See appended table 5.4.1.4) P
5.4.1.5 Pollution degree ................................................... : Pollution degree 2

5.4.1.5.2 Test for pollution degree 1 environment and for an
insulating compound
N/A
5.4.1.5.3 Thermal cycling N/A
5.4.1.6 Insulation in transformers with varying dimensions N/A
5.4.1.7 Insulation in circuits generating starting pulses N/A
5.4.1.8 Determination of working voltage P
5.4.1.9 Insulating surfaces P
5.4.1.10 Thermoplastic parts on which conductive metallic
parts are directly mounted
P
5.4.1.10.2 Vicat softening temperature ................................. : (See appended table 5.4.1.10.2) N/A
5.4.1.10.3 Ball pressure ....................................................... : (See appended table 5.4.1.10.3) P
5.4.2 Clearances P
5.4.2.2 Determining clearance using peak working voltage (See appended table 5.4.2.2) P
5.4.2.3 Determining clearance using required withstand
voltage ................................................................ :
(See appended table 5.4.2.3)
P