User Manual

8
Operation
This chapter describes some of HeadRush MX5’s basic functions.
Main Screen
Overview
Basic Operations
Important: The sequence of models in your signal chain is not necessarily reflected in the footswitches. You can
freely assign models to available footswitches without changing your signal chain at all—and vice versa. See
Hardware Assign to learn about this.
To assign a model (amp, cab, impulse response, or effect) to an empty slot, tap it ()
and then use the list that appears. See Rigs > Creating a New Rig to learn about this.
To rearrange the models in your signal chain, tap and drag a model to another slot or
between two other models (the ones after that position will shift one slot further down
the signal chain).
To activate or deactivate a model, press the footswitch assigned to it, or tap the
model and then tap the On/Off button that appears in the top right corner.
To switch an amp and/or cab between a dual and single configuration, tap the model
and then tap the X 2 button that appears in the top right corner.
To show a model’s settings screen, double-tap it.
Tap and drag this bar downward to view list of rigs.
Rig name.
Turn encoder to move
through selectable
items onscreen or to
adjust parameters.
Press encoder as an
Enter command.
Tap its footswitch to
activate or deactivate it.
Tap to view setlists.
Double-tap a model,
In, or Out to show its
parameters.
Tap to save rig.
These three blocks show the current
function of the three footswitches.
This button enables or
disables reverb and delay
tails when switching to
another rig.
This button toggles
between the different
routing options for a rig.