User Manual

30
Pedal Configuration:
External Pedal: This setting determines whether or not you are using an external expression pedal with the
HeadRush MX5.
• Tap On to use the built-in expression pedal to control the parameter/parameters of Bank A while your
external expression pedal controls the parameter/parameters of Bank B. (If you are using the
expression pedal’s Classic Mode, pressing the toe switch will activate or deactivate the parameter. If
you are using Advanced Mode, the toe switch will be disabled entirely.)
• Tap Off to disable the expression pedal input and use the built-in expression pedal only.
Reminders:
Confirm Unsaved: This setting determines whether or not
you will see a confirmation message if you change the rig
while there are unsaved changes on the current one. Tap
On to enable these messages or Off to disable them.
Alternatively, tap Do not show this dialog again in the
message itself to disable them.
MIDI Settings: These settings determine how the HeadRush
MX5 sends and receives MIDI information to and from external
devices. These settings affect only the HeadRush MX5’s MIDI
input or MIDI output.
MIDI Thru: Tap On to use the MIDI output as a MIDI
throughput; any MIDI information sent to the HeadRush
MX5’s MIDI input will be sent directly to the MIDI output.
Tap Off to use the HeadRush MX5’s MIDI output
normally; the HeadRush MX5 will be able to send its own
MIDI information out of the MIDI output.
Recv MIDI Clock: Tap On to enable the HeadRush MX5 to
receive MIDI clock information. Tap Off to use the
HeadRush MX5’s own internal MIDI clock (which will not
be sent out).
Prog Change: Tap Send to enable or disable the HeadRush MX5’s transmission of MIDI program change
messages when you load a rig. Tap Recv to enable or disable the HeadRush MX5’s reception of MIDI program
change messages from an external MIDI device.
MIDI Channel: This setting determines the MIDI channel(s) that the HeadRush MX5 will send and receive
MIDI messages. Tap this field, turn the encoder to select all channels (Omni), or 1–16, and then press the
encoder.
Assignments:
Auto Assign: This setting determines how models are assigned to the switches. Tap On if you want models to
be automatically assigned to the next available switch when you load them. Tap Off if you want models to load
without being assigned to a switch; you will have to assign them manually in the Hardware Assign screen.