User Manual

9
To show a model’s settings screen, double-tap it. Its
settings screen will appear with its preset menu, parameters,
and assigned color.
To activate or deactivate a model, press the footswitch
assigned to it, or tap the model’s footswitch in the display.
To switch an amp and/or cab between a dual and single
configuration, tap the 2X button next to it.
To load another rig (preset), do any of the following:
Press the upper-left (Rig ) or lower-left (Rig )
footswitch to load the previous or next rig
immediately.
Tap the name of the rig on the screen, and then tap
the or next to it.
Tap the name of the rig on the screen and then turn
the encoder.
Tap the magnifying-glass icon in the upper-left
corner, and use the virtual keyboard that appears to
enter a search term (e.g., part of the rig name). The
results will appear below. Tap a result to load that rig.
To create a new rig, tap the  button in the upper-right
corner, and then tap New Rig.
To delete the current rig, tap the  button in the upper-
right corner, and then tap Delete Rig, and then tap Yes to
continue or No to cancel.
Reverb/Delay Tail Spillover
If you have a reverb or delay effect active on your rig and then switch to a different rig, the reverb or
delay will continue to decay after switching to the second rig.
This feature is unavailable if you are using an effects loop or if you are using USB audio.
To enable or disable this feature for the current rig, tap Tail on the main screen. Alternatively, press
and hold the upper-left (Rig ) footswitch for one second.