User Manual

8
Operation
This chapter describes the HeadRush Pedalboard’s functions.
Main Screen
Overview
Basic Operations
Important: The sequence of models in your signal chain is not necessarily reflected in the footswitches. You can
freely assign models to available footswitches without changing your signal chain at all—and vice versa. See
Hardware Assign to learn about this.
To assign a model (amp, cab, or effect) to an empty slot, tap it () and then use the list
that appears. See Rigs > Creating a New Rig to learn about this.
To delete a model, tap and drag it to the bottom of the touchscreen over the Drag Here
to Delete bar that appears.
To show a model’s parameters on the right edge of the screen, tap the model so it is
outlined in green. You can then turn the parameter knobs to adjust the parameters to
their left. Tap anywhere in the column of those three parameters to show the next three (if
the model has more than three parameters).
When no model is selected, these parameters will be ones that you assign in the
Hardware Assign screen.
To rearrange the
models in your signal
chain, tap and drag a
model to another slot
or between two other
models (the ones after
that position will shift
one slot further down
the signal chain).
Tap and drag this bar downward to view list of rigs.
Rig name.
Double-tap a model,
In, or Out to show its
parameters.
Turn the parameter knobs to adjust these parameters. When a model is
selected, tap anywhere in this column to show the next three parameters.
Tap to save rig.
Turn encode
r
to move
through selectable
items onscreen or to
adjust parameters.
Press encoder as an
Ente
r
command.
Tap its
f
ootswitch to
activate or deactivate it.
Tap to view setlists.
Tap to search for rigs by name.
Tap for more options.