User Manual

29
USB Audio Settings:
Sample Rate: This setting determines the sample rate of the USB audio signal: 44.1 kHz, 48.0 kHz or 96.0 kHz.
Remember to select the same sample rate as the one in your DAW. Also, set it before opening your DAW.
USB Audio: This setting determines whether or not HeadRush pedalboard is sending a USB audio signal over
a USB connection. Tap On to enable sending of the USB audio signal with the selected Sample Rate. Tap Off
to disable the USB audio signal. (To change the Sample Rate, set USB Audio to Off first, select the correct
sample rate, set USB Audio to On again, and restart your DAW.)
USB Mode: This setting determines what audio signal how the HeadRush Pedalboard sends its audio signal
over the USB connection and how its outputs function while doing so:
Live: The audio signal will be sent to your computer as well as to the HeadRush Pedalboard’s outputs.
DAW: The audio signal will be sent to your computer only. The HeadRush Pedalboard’s outputs will be
disabled to prevent any latency while monitoring.
Reamp: Your computer will send an audio signal to the HeadRush Pedalboard, which will process it
through the current rig and send it back to your computer. The HeadRush Pedalboard’s outputs will be
disabled to prevent any latency while monitoring. See USB > Reamping to learn how to configure your
DAW for this process.
MIDI Settings: These settings determine how the HeadRush Pedalboard sends and receives MIDI information
from and to external devices. These settings affect only the HeadRush Pedalboard’s MIDI input or MIDI output.
MIDI Thru: Tap On to use the MIDI output as a MIDI throughput; any MIDI information sent to the HeadRush
Pedalboard’s MIDI input will be sent directly to the MIDI output. Tap Off to use the HeadRush Pedalboard’s MIDI
output normally; the HeadRush Pedalboard will be able to send its own MIDI information out of the MIDI output.
Recv MIDI Clock: Tap On to enable the HeadRush Pedalboard to receive MIDI clock information. Tap Off to
use the HeadRush Pedalboard’s own internal MIDI clock (which will not be sent out).
Prog Change: Tap Send to enable or disable the HeadRush Pedalboard’s transmission of MIDI program
change messages when you press the upper-left (Rig ) or lower-left (Rig ) switch. Tap Recv to enable or
disable the HeadRush Pedalboard’s reception of MIDI program change messages from an external MIDI device.
MIDI Channel: This setting determines the MIDI channel(s) that the HeadRush Pedalboard will send and receive
MIDI messages. Tap this field, turn the encoder to select all channels (Omni), or 1–16, and then press the encoder.