User Manual
27
To halve or double the speed of the looper, press the 1/2 Speed or 2X Speed footswitch, respectively. The
loop’s relative speed is shown in the Speed field.
Tip: Use this to create low bass lines or ultra-high guitar parts that you couldn’t play ordinarily.
To reverse looper playback, press the Reverse footswitch. The looper’s current playback direction is shown in
the Playback field.
Tip: Create eerie effects by recording layers in reverse then switching back to normal playback.
To mute or unmute the looper, press the Mute footswitch.
To set the looper’s location, turn the third parameter knob (Loc) to place it before (Pre) or after (Post) the
signal chain. Moving the looper to the Pre position enables you to edit your rig without having to play the same riff
over and over again
To exit the looper and return to the main screen, press the Exit footswitch. If the looper is playing, playback
will continue. Press and hold the Looper footswitch for one second to stop looper playback without re-entering
the looper.
You can re-enter the looper by simply pressing the Looper footswitch again.
Tip: Use this feature to create different effect configurations (adjust parameters, activate/deactivate models, etc.)
for each layer, creating a multi-textured performance. You can also switch rigs while using the looper and use a
different rig for each layer.