User Manual

25
To load a setlist:
1. While viewing the main screen, tap the button in the
upper-left corner to view the Setlists screen. Each setlist
will show the number of rigs in parentheses (including
multiple instances of the same rig).
2. Optional: Tap the magnifying-glass icon in the upper-
left corner, and use the virtual keyboard that appears to
enter a search term (e.g., part of the setlist name). The
results will appear below.
3. Tap the desired setlist. The first rig of that setlist will load
immediately. Tap All Rigs to view all rigs instead of a
specific setlist.
To edit a setlist, tap the  button on its left side, and then
tap the pencil icon. You will see the same screen you used
to create the setlist, where you can edit and save it.
To delete a setlist, tap the  button on its left side, and
then tap the trash can icon. Tap Yes to confirm the deletion
or Cancel to return to the Setlists screen without deleting it.
Hands-Free Mode
Hands-Free Mode enables you to adjust any of the settings
on your models by using just the footswitches and expression
pedal.
To enter Hands-Free Mode, press and hold a footswitch
assigned to a model for over one second. While in Hands-
Free Mode, the screen will show a single parameter and its
value, and the top six footswitches will correspond to six
parameters of that model.
To exit Hands-Free Mode, press the lower-left most (Exit)
footswitch.
To change the value, move the expression pedal.
To fine-tune the value incrementally, use the lower-right two
( or +) footswitches.
To show another parameter, press the corresponding
footswitch. If that model has more than six parameters,
press the lower-middle two ( or ) footswitches to show
the previous or next six parameters.
If you are using a double-amp and/or double-cab configuration
(2X), use the 12 footswitch to switch between the two.