User Manual
22
Scenes
The Scene feature allows you to turn multiple models on or off in each rig. When you press the footswitch
assigned to that scene, all models included in that scene will turn on or off, depending on how you assign them.
This is a great way to create multiple tones in the same rig. For instance, you may want a particular reverb model
to be on anytime a particular distortion model is also on. Alternatively, you may want to turn one delay model off
when you turn another one on. Scenes enable you to do this with only one footswitch press.
To create and edit a scene:
1. On the Hardware Assign screen, tap Toggle/Hold/Scene
for the desired footswitch to cycle through the available
options, and select Scene.
2. On that model, tap Edit. The Scene Editor will appear,
which shows all models in your rig.
3. For each model in the rig, tap it to cycle through the
available options:
On: This model will turn on when you turn the scene on.
Off: This model will turn off when you turn the scene on.
No Change: This model will remain unaffected when
you turn the scene on.
4. Tap a color at the bottom of the touchscreen to select a
color for the scene.
5. Tap the button in the upper-left corner to return to the
Hardware Assign screen.
To rename a scene (which appears in the footswitch
indicators), tap the text in the box below Edit on the model,
use the virtual keyboard that appears to enter a name, and
then tap anywhere other than the text field.
Quick Parameters
The right edge of the screen shows a column of fields for three parameters. These are the three
parameters that are shown first whenever you load a rig. When no model is selected on the main
screen, you can turn the three parameter knobs to adjust these parameters. You can assign any
continuous parameters to these knobs (parameters with a range of values rather than ones with only
“on” and “off” states).
To assign a parameter to a parameter knob:
1. Tap the field to which you want to assign a parameter. indicates an empty field.
2. In the list that appears, tap the model with the parameter you want to assign. You can also select
parameters for the incoming signal (Input) or outgoing signal (Output).
3. In the list that appears, tap the parameter you want to assign.
Tap Unassigned to unassign that parameter knob.