User Manual
21
Footswitches
The eight boxes in the lower-left corner represent the middle eight footswitches of the HeadRush Pedalboard.
You can assign any switch-based parameters (ones with only two states) to any of the footswitches—regardless
of their location in the signal chain.
To assign a parameter to a footswitch:
1. Tap a box. indicates an empty box.
2. In the list that appears, tap the model with the parameter you
want to assign.
3. In the list that appears, tap the parameter you want to
assign. Usually, the parameter will simply be On (to activate
or deactivate it).
Tap Unassigned to unassign that footswitch.
4. On the Hardware Assign screen, tap Toggle/Hold/Scene for
that footswitch to cycle through the available options:
When set to Toggle, each press will turn the model on or off.
When set to Hold, pressing and holding the footswitch will
activate it, and releasing the footswitch will deactivate it.
When set to Scene, each press will turn a scene on or off. A
scene is a collection of “linked” models in the rig—all of
which will simultaneously turn on or off when you press that
scene’s footswitch. See the Scenes section to learn about
this feature.
To swap two assignments, tap and drag one of them over the
other, and then release it.
To edit the text displayed above the footswitch, tap the text in
the box below the model name, use the virtual keyboard that
appears to enter a name, and then tap anywhere other than the
text field.