User Guide

10
You can use the Timeline page to view the waveforms of the tracks in your loop.
To show the Timeline page, tap the waveform icon at the top of the touchscreen.
The time counter in the lower-left corner indicates the current playback position of the loop. The
time counter in the lower-right corner indicates the length of the longest track in the loop. Both are
displayed as minutes:seconds.deciseconds.
Track Modes
Located at the bottom of the touchscreen in Timeline View, the Track Mode selection provides 5
different modes for Looperboard to record, overdub, and play your looper tracks. Generally, each
mode supports a different style of looping workflow. The best way to find out which Track Mode
works best with your workflow is to experiment and have fun!
To set how the looper records, overdubs, or plays your tracks, tap a Track Mode button at the
bottom of the Timeline page:
Important: You must select Fixed, Sync, or Serial-Sync track modes before recording or
importing audio into your loop. Once you have recorded or imported audio, you can only select
Serial or Free track modes.
1. Fixed Mode: Use this mode if you want 4 looper tracks with the same length. In this mode:
• You can record, overdub, or play all looper tracks simultaneously.
• All track lengths will be the same length as the first recorded looper track.
• When you set a track to record, overdub, or play, it will happen immediately.
2. Serial Mode: Use this mode if you want to use each of the 4 looper tracks as a different section
of a song (e.g., verse, chorus, bridge, and outro). In this mode:
• You can record, overdub, or play on only one looper track at a time.
• All looper tracks can be different lengths.
• When you set a track to record, overdub, or play, it will begin when the playhead has
reached the end of the loop and starts at the beginning again.