Instruction Manual
Instruction Manual
8093127
OPERATING INSTRUCTIONS
Prior to rst use, remove the plastic battery isolator tabs located on the earbud charging pins.
TO DO THIS
Play Music Press either MFB button.
Pause Music Press either MFB button.
Next song Press and hold the right MFB button for 2 seconds.
Previous song Press and hold the left MFB button for 2 seconds.
Activate/Stop Voice Assistant Press either MFB button twice.
Answer a call Press either MFB button.
End a call Press either MFB button.
Reject an
incoming call
Press and hold either MFB button for 2 seconds.
Switch to talk via phone Press either MFB button three times.
Hold current call,
answer second call
While on a call, press either MFB button once to answer
the 2nd call and put the 1st call on hold.
End current call, answer rst call Press and hold either MFB button for 2 seconds.
Turn off earbuds (without
putting them in charging case)
Press and hold either MFB button for 5 seconds.
NOTE: The function compatibility may vary among different
smartphones or devices. Not all functions are available on all devices.
FIT
We recommend that you try each ear tip (small, medium and large),
then perform a sound check and choose the combination that provides
the best sound experience.
CHARGING THE CASE
Use the included charging cable to fully charge the case before rst
use. It will take approximately 1.5 hours to fully charge.
The blue LEDs will ash during charging, and remain ON when
charging is complete.
1 LED ON indicates power level is lower than 25%.
2 LEDs ON indicates power level is between 25%~50%.
3 LEDs ON indicates power level is between 50%~75%.
4 LEDs ON indicates power level is between 75%~100%.
NOTE: To check the remaining case battery power when it is not
charging, please open the case lid and take out the earbuds.
CHARGING THE EARBUDS
1. The earbuds will beep when the battery is low.
2. Place both earbuds into the charging case. The LED indicator will
ash white when the earbuds are charging and will turn OFF when
charging is complete.
NOTE: Remove the plastic battery isolator tabs located on the
earbud charging pins. When the earbuds are paired to an Android
™
or iOS device, remaining earbud battery power will show on the
device display.
PAIRING
The earbuds will automatically enter Bluetooth
�
pairing mode
when used for the first time. The left and right earbuds connect to
each other.
1. Open the lid of the charging case and take the earbuds out. The
earbuds will automatically turn ON. The LED will ash white and
blue and the earbuds will beep to indicate that they have entered
pairing mode.
2. Select “HRB 3032” on the Bluetooth
�
device list to pair the
earbuds automatically.
3. The earbuds will beep when Bluetooth
�
is successfully connected.
4. After initial pairing, the earbuds will automatically turn ON and
connect to your device when removed from the charging case,
provided both earbuds and your Bluetooth
�
are ON and
within range.
5. The earbuds will automatically turn OFF after 6 minutes if no
connection is established.
TO USE ONLY THE LEFT OR RIGHT EARBUD
If both earbuds are turned ON and paired to your device, you can
return the right or left earbud to the charging case and the earbud
(R or L) in your ear will continue to play. To use the right or left earbud
only, remove it from the charging case. It will turn ON and connect
automatically to your device.
RESET
If the left and right earbuds do not connect to each other, you will
need to reset the earbuds and clear paired memory.
1. Remove “HRB 3032” from your device and turn Bluetooth
�
OFF
on your device.
2. Put both earbuds back into the charging case, then press and hold
both MFB buttons for 5 seconds.
3. The blue LED will ash 3 times. This indicates that the reset
procedure has been completed.
4. Turn Bluetooth
�
back ON in your device settings and
select ‘’HRB 3032”
OPERATION
• If the earbuds were paired to your device previously, take the
earbuds out of the charging case. The earbuds will power ON and
connect to your device automatically
• If the earbuds are not in the charging case and have powered OFF,
press and hold both MFB buttons for 2 seconds to power ON
• While playing music, press either MFB button to pause,
press again to resume
• Press and hold the right MFB button for 2 seconds for the next
song, press and hold the left MFB button for 2 seconds for the
previous song
• The music will pause and the earbuds will ring when there is an
incoming call. Press either MFB button once to answer the call,
press and hold to reject the call
• To turn the earbuds OFF without returning them to the charging
case, press and hold either MFB button for 5 seconds. The white
LEDs will ash 3 times and power OFF
WARNING!
• Supervise children when using equipment, this product is not a toy
• Listening to earbuds at high volume levels, particularly over
extended periods of time may damage your hearing
• If you have a pacemaker or other electrical medical devices, you
should consult your physician before using this product
• The operation of switching on your Hi-Fi system or plugging in the
earbuds may cause clicks which at high volume setting may affect
your hearing. Therefore, always set the volume control to minimum
before switching between different sources (tuner, turntable, CD
player, etc.) or plugging in the earbuds
• DO NOT use earbuds while driving or cycling
• The small parts included with this product can be a choking hazard.
This product is not intended for use by small children and should be
kept away from children under 3 years of age
• If not used for long periods, it is recommended to charge the
earbuds and case at least every 3 months
• Please dispose of rechargeable batteries properly. DO NOT dispose
of batteries in re to prevent an explosion
TRUE WIRELESS
EARBUDS
HRB 3032
INTRODUCTION
Thank you for purchasing the HRB 3032 true wireless earbuds.
In order to maximize your listening experience please read the
following instructions.
WHAT’S INCLUDED
• HRB 3032 earbuds
• Charging case
• Small, medium and large earbud tips
• USB-C charging cable
• Instruction manual
1
2
3
Charging pins
Charging case LED indicator
USB-C charging port
MFB (Multi-function button)
Earbuds LED indicator
Charging contact point
Ear tips
TROUBLESHOOTING
No sound
• Please check the volume on your audio device to make sure it is
outputting sound
Connection Problems
• Please return the earbuds to the case and then remove them again
if there are any connection issues
• Refer to the cleared paired memory and reset section
The earbuds are not tting comfortably
• Please switch out the earbud tips to a different size to find the
appropriate fit
Improving the Sound
• Sound can sometimes be improved by moving to a larger eartip
size. The eartips still need to fit comfortably in your ear
CLEANING
Your earbuds may require periodic cleaning. Remove the tips from the
earbuds and wash them with a mild detergent and water. Make sure
the tips are dry before putting them back on the earbuds.
IMPORTANT SAFETY INFORMATION
CAUTIONS
• Keep in a safe place free from dust, liquid and extreme temperatures
• DO NOT attempt to disassemble the product
• DO NOT use chemicals to clean the product
SPECIFICATIONS
EARBUDS
Bluetooth
®
version: V5.0
Bluetooth
®
proles*: HSP;HFP;A2DP;AVRCP
Wireless range: 10m (32ft.)
IP rating: IPX4
Playback time: Approx. 4 hours**
Number of charges
from case: 2
Charging time: Approx. 1.5 hours
Imported by:
The Source, Barrie, Ontario, Canada, L4M 4W5
Manufactured in China
www.thesource.ca
© 2021 The Source. All rights reserved.
Please
Recycle
4
5
Standby time: Approx. 55 hours
Rated input: DC 5V/45mA
Driver diameter: 6mm
Sensitivity: 92dB±3dB
Frequency response: 20Hz-20kHz
Impedance: 16Ω±15%
Battery: Polymer Lithium
Battery Capacity: 45mAh
CHARGING CASE
Rated input: DC 5V, 500mA
Output: DC 5V, 300mA
Battery capacity: 350mAh
*A2DP=Advanced Audio Distribution Prole, AVRCP=Audio Video Remote Control Prole, HSP=Handset Prole,
HFP=Handsfree Prole.
**Approximate playback time, battery life depends on individual use and may be more or less than specied.
*** Bluetooth
®
connected, power ON, no music playing.
The Bluetooth
®
word mark and logos are registered trademarks owned by Bluetooth
®
SIG,
Inc. and any use of such marks by The Source (Bell) Electronics Inc. is under license. Other
trademarks and trade names are those of their respective owners.
INDUSTRY CANADA NOTICE RSS247
This device complies with Industry Canada license-exempt RSS standards(s). Operation is
Subject to the following two conditions:
• This device may not cause interference, and this device must accept any
interference,including interference that may cause undesired operation of the device
• This digital apparatus does not exceed the Class B limits for radio noise emissions from
digital apparatus set out in the Radio Interference Regulations of Industry Canada
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital
apparatus set out in the Radio Interference Regulations of Industry Canada.
ISED REGULATORY COMPLIANCE
This device contains licence-exempt transmitters that comply with Innovation, Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following
two conditions:
• This device may not cause interference
• This device must accept any interference, including interference that may cause undesired
operation of the device
This equipment complies with IC RSS-102 radiation exposure limits set forth for an
uncontrolled environment.
IC:255A-8093127
CAN ICES-003(B)/NMB-003(B)
The Source warrants that this product will be free from defects in materials and workmanship for a period of
twelve (12) months from the date of purchase. Within this period, simply take the product and your proof
of purchase to any The Source store or participating dealer and the product will be replaced (where available)
without charge. Any product which has been subject to misuse or accidental damage is excluded
from this warranty.
This warranty is only applicable to a product purchased through The Source company-owned stores or participat-
ing dealers in Canada where the warranty is included with the product. While this warranty does not confer any
legal rights other than those set out above, you may have additional statutory rights which will vary under the
laws of the various countries, states, provinces and other governmental entities in which
The Source operates. This warranty is subject to all statutory rights you may have in Canada.
THE SOURCE - WARRANTY
1
2
3
4
6
7
5
6
7
0~25% 25%~50% 50%~75% 75%~100%
Additional large and small earbud tips included
(medium tips installed on earbuds).