User's Manual

LAND MOBILE RADIO
HL-1000 SERIES
LAND MOBILE RADIO
HL-1000 SERIES
Operation
14
13
5) 2TONE ANI
Select the 2TONE ANI function pressing the
"F" button 5 times, the icon " " will begin
flashing. Select On/Off with the Up/Down
buttons, it'll be then stored automatically at the
same time. If no buttons are pressed in 5 sec-
onds after selecting functions, the display will
switch back to the main display. Press the PTT
button to finish the function mode.
You should turn off the 2TONE ANI during
the general communication. Otherwise,
receiving transmission can be unavailable.
6) CHANNEL SCAN
Select the Channel Scan pressing the "F" button
6 times, the icon " " will be indicated on the
display.
This function helps you find channels automa-
tically which other radio uses. The unit will now
begin scanning through the channels, and
channel numbers will scroll on the display rapidly
from low number to high number.
(See the additional instruction of Channel Scan)
This function activates only with the external PC program, and trans-
mits 2TONE that is already saved in whenever you press the PTT but-
ton. You can receive only when 2TONE is sensed. You can communi-
cate each other only using the radio which 2TONE is saved in without
other radio's interference. If you want to have a general communication
with other radio regardless of 2TONE, switchover this function to off.
3) KEY LOCK
Press the "F" button three times to set up 'Key
Lock', the icon " " will begin flashing.
Select On/Off using the Up/Down buttons, it'll
be then stored automatically at the same time.
If no buttons are pressed in 5 seconds after
selecting functions, the display will switch back
to the main display. Press the PTT button to
finish the function mode. This function locks
the channel you are currently using and other
channels can't be chosen. Press the "F" button
for two seconds to release the Key Lock funtion.
4) DTMF
Set up the DTMF Transmission using the "F"
button 4 times, the icon " " will begin flashing.
Select On/Off with the Up/Down buttons, it'll be
then stored automatically at the same time.
If no buttons are pressed in 5 seconds after
selecting functions, the display will switch back
to the main display. Press the PTT button to fin-
ish the function mode. If DTMF is on, you can
hear the unique sound of DTMF whenever you
press the PTT button. This function notifies you
of receiving messages. You just can communi-
cate with others after receiving transmission,
not at the same time.
Operation
Press the 'F' button three
times to set up 'Key Lock'.
Press the 'F' button 4 times.
Press the 'F' button 5 times.
Select the Channel Scan pres
-sing the 'F' button 6 times.