User's Manual

LAND MOBILE RADIO

HL-1000 SERIES

LAND MOBILE RADIO

HL-1000 SERIES

(2) Receive and Transmit During Scanning Channel

If there is a signal reception and transmission during scanning chan-

nel, scanning will be stopped at the channel. At this time, you can

transmit according to the transmit way by pressing the PTT.

(3) How to Transmit During Scanning

You can transmit by pressing the PTT button while you are scan-

ning.

1. The channel just prior to progress scanning (HOME Channel)

2. The current channel on scanning (Optional scan channel)

3. Received final channel

You can specify the external PC program with these 3 transmit

ways, current radios are specified with a final received channel.

(4) Progress the Channel Scan

When the radio catches any signals, scanning will be stopped on

that channel for about 2 seconds, and resume scanning from the

next channel. It is possible to set up with the external PC program.

If the scanning stops on the channel that you detect and if you

want to keep scanning after communication, press the "Up" button

to resume scanning to the next channel.

(5) Temporary Deletion Channel on Scanning

You can delete a scanned channel temporarily if there are many

channels you want to scan. Press the "Down" button, the channel

will be then deleted temporarily. When you finish scanning and

start it again, the channel you deleted will be restored to the mode

just before deleting channels.

You can register the channel which you want to scan

among the channels in the radio as using the exter-

nal PC program or through the registration mode of

the scan channel in the radio. (See the registration

and cancellation of the scan channel in a special

mode.)

* How to Register the Scan Channel

Additional Instruction of Scan Channel