Installation Manual

Page 9 OfficeSense sensor installation v1.1
Mounting the Comfort Sensor
Comfort SensorComfort Sensor
Comfort Sensor
The Comfort sensor is advised to be mounted to the wall of the room at a height of
approximately 1.80 meters. Provided in the shipping box are strips of double-sided tape
which can be used to mount the sensor.
Deploying sensors using the double-sided tape
1) Open the Comfort sensor by removing the baseplate (turn anti-clockwise).
2) Stick the tape to the baseplate of the sensor, as shown below.
3) Clean the surface of the wall at a height of 1.80m from dust, dirt and grease.
4) Make sure the target surface is flat and dry (no relief surface).
5) Stick the baseplate to the surface of the wall with the tape, press firmly.
6) Scan QR code of the sensor and remove the battery-pull-tab to activate it.
7) Attach the sensor to the baseplate by turning it clockwise on the baseplate.
Deploying sensors using two screws (not included)
The baseplate of the sensor has openings to screw the device onto the wall.
1) Open the Comfort sensor by removing the baseplate (turn anti-clockwise).
2) Position the baseplate and mark the two drill holes by using a pencil.
3) Remove the baseplate and drill holes.
4) Use a screwdriver to install the baseplate at the desired location.
5) Scan QR code of the sensor and remove the battery-pull-tab to activate it.
6) Attach the sensor to the baseplate by turning it clockwise on the baseplate.