Installation Manual

Page 24 OfficeSense sensor installation v1.1
Regulations
Legal notices
All information, including, but not limited to, information regarding the features,
functionality, and/or other product specification are subject to change without notice. The
manufacturer reserves all rights to revise or update its products, software, or
documentation without any obligation to notify any individual or entity. All brands and
product names referred to herein are trademarks of their respective holders.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Non-modifications statement
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
Caution
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may
cause undesired operation.
(3) This device and its antenna(s) must not be co-located or operating in conjunction
with any other antenna or transmitter except in accordance with FCC multi-
transmitter product procedures.
Declaration of conformity
Hereby, the manufacturer declares that OfficeSense sensor is in compliance with the
essential requirements and other relevant provisions of Directive 1999/5/EC.