Installation Manual

Page 12 OfficeSense sensor installation v1.1
Desk Sensor
The following steps provide an extensive overview of the full installation process and are
intended for the building manager and/or installation coordinator.
Check Package contents
You have received a set of Desk sensors in a box. The box contains the following:
Contents of the box
Casing Strips of double-sided tape
Baseplate PCB (inside casing)
The sensors that are shipped are based on your country. Please check if the label on the
box matches your region. Do note that the Desk sensor normally is not shipped with
batteries included. One should make sure sufficient batteries are available (2 AA batteries
per desk sensor).
Preparing the desk sensor
After unpacking the box and checking whether it’s complete, the sensors can be installed.
To do so, please follow the steps below. Please note: these steps should be completed
per desk individually.
1) Insert 2 AA batteries into battery-casing
a) Note the proper orientation of the batteries (+ and -)
b) The desk sensor starts working as indicated by the integrated LED
2) Close casing
a) Make sure the casing and baseplate are correctly aligned
3) Apply double-sided tape (see picture below).
 Repeat above steps at every desk.