Installation Manual

Page 10 OfficeSense sensor installation v1.1
Mounting the Presence
Presence Presence
Presence Sensor
SensorSensor
Sensor
There are multiple options to mount the sensor to the ceiling of the room. Provided in the
shipping box are either strips of double-sided tape or special ceiling clips which can be
used to mount the sensor.
Deploying sensors using the ceiling clip (optional)
Note: the ceiling clip can be used with suspended ceiling constructions with metal strips
with a width of up to 2.5 cm.
1) Open the sensor by removing the baseplate (turn anti-clockwise).
2) Attach the ceiling clip to the ceiling.
3) Attach the sensor baseplate on the clip (you will hear a click!).
4) Scan QR code of the sensor and remove the battery-pull-tab to activate it.
5) Attach the sensor to the baseplate by turning it clockwise on the baseplate.
Deploying sensors using the double-sided tape
1) Open the sensor by removing the baseplate (turn anti-clockwise).
2) Stick the tape to the baseplate of the sensor, as shown below.
3) Clean the ceiling surface from dust, dirt and grease.
4) Make sure the target surface is flat and dry (no relief surface).
5) Stick the baseplate to the ceiling surface with the tape, press firmly.
6) Scan QR code of the sensor and remove the battery-pull-tab to activate it.
7) Attach the sensor to the baseplate by turning it clockwise on the baseplate.
Deploying sensors using two screws (not included)
The baseplate of the sensor has openings to screw the device onto the wall.
1) Open the sensor by removing the baseplate (turn anti-clockwise).
2) Position the baseplate and mark the two drill holes by using a pencil.
3) Remove the baseplate and drill holes.
4) Use a screwdriver to install the baseplate at the desired location.
5) Scan QR code of the sensor and remove the battery-pull-tab to activate it.
6) Attach the sensor to the baseplate by turning it clockwise on the baseplate.