Instructions / Assembly

PACKAGE CONTENTS

A - WIRE DRAWER x1 B - LEFT SLIDE x1 C - RIGHT SLIDE x1

D - RACK PLATE x4 E - PLATE SCREW x4

F - CABINET SCREW x4

G - CABINET MOUNTING

TEMPLATE x1

Instructions –on wire rack

Note: You will need a Phillips screwdriver for assembly.

A rubber mallet is also recommended.

Identify LEFT & RIGHT SLIDES (B) & (C).

・ Note that the BACK end of each SLIDE (B) & (C) has

a black tip and the FRONT end does NOT.

Place SLIDES (B) & (C) on desired wire shelf. Make

sure the FRONT of the SLIDES (B) & (C) is lined up with

the FRONT of the shelf.

Line up the slides along the wires in the wire shelf to

ensure they are straight. Make sure the front edge of

the WIRE DRAWER (A) lines up to the edge of the shelf

so they are flush.

CLIPS should be on th

e OUTS

IDE.

STEP 1

FRONT

BACK

Rest WIRE DRAWER (A) on top of the CLIPS to ensure

proper SLIDE spacing.

・ Note: For ease of installation, do NOT clip the WIRE

DRAWER (A) into the LEFT & RIGHT SLIDES (B) &

Position as such:

STEP 2

PAGE 1
PACKAGE CONTENTS A - WIRE DRAWER x1 B - LEFT SLIDE x1 C - RIGHT SLIDE x1 D - RACK PLATE x4 E - PLATE SCREW x4 Note: You will need a Phillips screwdriver for assembly. A rubber mallet is also recommended. F - CABINET SCREW x4 G - CABINET MOUNTING TEMPLATE x1 Instructions –on wire rack STEP 1 STEP 2 Identify LEFT & RIGHT SLIDES (B) & (C). ・ Note that the BACK end of each SLIDE (B) & (C) has a black tip and the FRONT end does NOT. Rest WIRE DRAWER (A) on top of the CLIPS to ensure proper SLIDE spacing.
PAGE 2
Instructions –on wire rack STEP 3 STEP 4 With a Phillips screwdriver, secure the SLIDES (B) & (C) to the wire shelf by putting PLATE SCREWS (E) through the slots and fasten to the RACK PLATES (D). Attach the WIRE DRAWER (A) to the clips in the LEFT and RIGHT SLIDES (B) & (C) until it clicks into the clip.
PAGE 3
Instructions –in cabinet STEP 3 Align WIRE DRAWER (A) at the marked location and push it into the clips of the LEFT & RIGHT SLIDES (B) & (C). Installation Suggestion: With the WIRE DRAWER (A) resting on top of the clips, brace the top of the WIRE DRAWER (A) with one hand and, with a rubber mallet, lightly tap each bottom corner of the WIRE DRAWER (A) to secure the WIRE DRAWER (A) into the clips. Safety Information 1. Read and understand all instructions.