Instructions / Assembly

HOMEDEPOT.COM/HDX
Installation Guide
Reverse Osmosis
Replacement Membrane
ITEM #1001001851
MODEL #HDXROM010
Designed as a Replacement Membrane for GE
®
Models # GXRM10GBL and # GXRM10RBL
Installation
1
PREPARING FOR INSTALLATION
NOTE: Ensure you have the original
owner’s manual for reference while
completing this installation process.
□ If the Reverse Osmosis (RO) system
is attached to an icemaker, the
icemaker must be turned OFF.
□ To avoid contamination, wash hands
with anti-bacterial soap before
replacing the membrane.
□ Turn off the cold water supply.
□ Turn on the RO faucet and drain the
tank. After several minutes when the
tank is completely drained, turn the
RO faucet OFF.
CAUTION: If the tank shut-off or water
supply valve is not closed, the water will
run out or spray when the membrane is
removed.
COLD
2
INSTALLING THE NEW
MEMBRANE
NOTE: You must refer to the original
sanitization steps.
□ Disconnect the tubing and remove
the RO Membrane cap. Then remove
the used RO Membrane cartridge.
Discard the used cartridge and
place in a plastic bag for disposal.
Wipe the cap and housing with a
clean towel and rinse well. Insert
the new membrane cartridge with
should be lubricated with food-grade
silicone grease only. Replace the RO
Membrane cap.
□ When replacing the RO Membrane
control). Remove the black ¼” line
3
FLUSHING THE SYSTEM
NOTE:
for at least 24 hours prior to drinking
the storage tank three times until the
taste and odor from the food-grade
preservative is gone.
□ Turn the water supply on and open
approximately one minute.
□ Open the faucet again and allow water
to run for approximately 10 minutes.
Close the faucet again for one minute
another 10 minutes until the bleach
odor from the sanitization process is
gone. Turn the water supply off and
drain the RO system.
clean knife edge. Discard the used
restrictor and screen if one is present
and replace with a new restrictor. The
new restrictor eliminates the need
for the additional screen part. Hand
tightening with pliers by turning ¼
turn. DO NOT OVERTIGHTEN.
Maximum Water Pressure 125 (PSI)
Maximum Water Temperature 100°F
lead content and compliance.
4
COMPLETING THE INSTALLATION
□
connections for leaks. Fill and empty the storage tank as needed until taste and odor from the silicone grease is gone. After the RO
Warranty
6-MONTH LIMITED WARRANTY
This warranty covers defects in materials and workmanship from the original date of purchase. During the warranty period, we will replace any part which
in our opinion is defective, if the housing has not been subjected to tampering, alteration or improper use after delivery, and has not been repaired by anyone
except us. Our obligation does not include the cost of transportation. We are not responsible for damage in transit, and claims for such damage should be
presented to the carrier by the customer. The housing is not warranted against misuse, use in abnormal temperature conditions, or in a commercial operation.
WE MAKE NO WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING, WITHOUT LIMITATION, ANY WARRANTIES OF FITNESS OR MERCHANTABILITY EXCEPT AS
EXPRESSLY SET FORTH ABOVE. WE SHALL NOT BE LIABLE FOR ANY ANTICIPATED OR LOST PROFITS, INCIDENTAL DAMAGES, CONSEQUENTIAL DAMAGES,
COSTS, TIME CHARGES OR OTHER LOSSES INCURRED IN CONNECTION WITH THE PURCHASE, INSTALLATION, REPAIR OR OPERATION OF HOUSING OR SYSTEM.
WE DO NOT AUTHORIZE ANYONE TO ASSUME FOR US ANY LIABILITY IN CONNECTION WITH THE HOUSING OR SYSTEM OR ANY PART THEREOF.
Contact the Customer Service Team at 1-844-832-0822 or visit WWW.HOMEDEPOT.COM/HDX.
GE is a registered trademark of General Electric Corp.
TOOLS REQUIRED
Tape measure Safety goggles Utility knife Bucket
PACKAGE CONTENTS
Reverse Osmosis Membrane Restrictor
Service Requests/Product Information:
844-832-0822
Protect Plus, LLC Hickory, NC 28601 USA