Use and Care Manual

Operation Continued)-((Model#HDXBR50) OperationContinued)-((Model#HDXFN64)
Firing the tool
6
The tool is specially designed for single sequential mode.
This mode requires the trigger to be pulled each time a
fastener is driven. The tool can be actuated by depressing
the Work Contact Element(WCE) (G) against the work
surface followed pulling the trigger(H).
The trigger must be released to reset the tool before
another fastener can be driven.
WARNING:Always know the operational mode of the
tool before using. Failure to know the operational
mode could result in death or serious personal injury.
WARNING:An improperly functioning tool must not be
used. Do not actuate the tool unless the tool is placed
firmly against the work place.
Work contact element(WCE)
7
Disconnect the air supply from the tool.
Remove all fasteners from the magazine.
Make sure the trigger and work contact element move
freely up and down without sticking or binding.
Reconnect air supply to the tool.
Depress the work contact element against the work
surface without pulling the trigger, the tool must not
operate. Do not use the tool if it operates without pulling
the trigger. Personal injury may result.
Remove the tool from the work surface, the work contact
element (WCE) must return to its original down position,
the tool must not operate. Do not use the tool if it operates
while lifted from the work surface. Personal injury may
result.
Pull the trigger and depress the work contact
element(WCE) against the work surface, the tool must not
operate.
Depress the work contact element (WCE) against the
surface, pull the trigger, the tool must operate.
CAUTION:Check the operation of the work contact
element trip mechanism before each use. The WCE
must move freely without binding through its entire
travel distance. The WCE (I) spring must return the
WCE to its fully extended position after being
depressed. Do not operate the tool if the WCE trip
mechanism is not operating properly. Personal injury
may occur.
Adjusting the exhaust
1
Theadjustableexhaustonthecapofthetoolallows
userstodirecttheexhaustaccordingtooperator
preference.Toadjustthedirection, turntheexhaustcapin
thedesireddirection.
Loading Fasteners
2
Connectthetooltotheairsource.
Pullpusher (B)backtomagazinerail until it locked into
Pusher hook (B-1).
PusherB()
Air inlet
Pusher hook
(B-1)
Pusher hook
(B-1)
16GaFinishnails.
InsertstripoffastenerintomagazinefromthetopUp
to100pcsnailscanbeloadedintomagazine. Be sure
the fasteners are pointed DOWNWARD.
.
Press the pusher hook(B-1), then slowly release the
pusher (B), it slides back to the magazine. Then pusher
will stop when it rests against the end of fasteners.
Pusher(B)
Pusher hook
(B-1)
18
19
Trigger(H)
Work contact
element (G)
WCE Spring (I)
HOMEDEPOT.COM
Please contact 1-800-514-6729 for further assistance.