User Manual

5. Operation Controls and Functions
5.1 Transmitter Panel
RJ45 connector for connecting the CAT IN port of the Receiver
with CAT6/6a cable.
CAT OUT
Firmware update port.
EDID DIP
switch
Use the DIP switch to set EDID. (Switching to the upper end
indicates 1; switching to the lower end indicates 0.)
11 - EDID information is copied from the display at the RX.
10 - EDID is preset to 4K@60Hz 2.0CH
01 - EDID is preset to 1080p 2.0CH
00 - EDID information is copied from the HDMI OUT at the TX.
4 / 6
Function DescriptionName
SERVICE
No.
1
2
3
Data Signal
Indicator
(Yellow)
7
4
6
Link Signal
Indicator
(Green)
8
9
HDMI OUT
HDMI signal loop output port. Connect to HDMI display devices
with HDMI cable.
HDMI IN
HDMI signal input port. Connect to HDMI source device with
HDMI cable.
PC
Connect to PC. The computer can be accessed and controlled
remotely through the USB port of the receiver (KVM function).
5
DC 12V
DC 12V/1A power input port.
Note that the extender supports POC function, it means that either
Transmitter or Receiver is connected to 12V/1A power supply, the other
doesn’t need power supply.
▪ Illuminating: Transmitter and Receiver are in good connection status.
▪ Flashing: Transmitter and Receiver are in poor connection status.
▪ Dark: Transmitter and Receiver are not connected.
▪ Illuminating: HDMI signal with HDCP.
▪ Flashing: HDMI signal without HDCP.
▪ Dark: No HDMI signal.
5
6
1 2 3 7
9
84