User manual

13
An optical Toslink–Toslink or coaxial (75 Ohm) audio cable shall be used (not includ-
ed).
1. Connect digital audio output of the player to the digital audio input of the AV receiver.
2. Select relevant input and sound mode on the AV receiver.
 We recommend you to turn down the volume of your audio equipment before
connection, in order to protect your hearing from unexpectedly high volume, and to
eliminate the risk of damage to your audio system.
Transmission of Digital Audio to AV Receiver via Op-
tical/Coaxial Cable
Transmission of Digital Audio to AV Receiver via
HDMI Input
This media player is equipped with an up-to-date HDMI 1.3 interface, allowing trans-
mission of digital video and audio streams via a single cable. If your AV receiver has
an HDMI 1.3 input and decoders for up-to-date audio formats, you may fully enjoy
an HD multichannel sound.
1. Make sure that the player and the AV receiver are switched off. Do not switch them on until
the connection procedure is finished.
2. Connect the HDMI output of the media player to the HDMI input of your AV receiver using
an HDMI-HDMI cable.
3. Using the RC/buttons of the AV receiver, select an appropriate mode (refer to your AV
receiver manual).
 We recommend you to turn down the volume of your audio equipment before
connection, in order to protect your hearing from unexpectedly high volume, and to
eliminate the risk of damage to your audio system.
Connections
HD MI I N