User manual

11
HD MI I N
Connections
This chapter describes different possibilities of connecting the media player to AV
equipment.
 Depending on the model and the design of a TV/monitor/projector, after connecting it
using one of the provided schemes and plugging in the power, the player initialization may
take up to 10 sec. If after this time there is no picture (a "DUNE" logo) on the screen, then it
is a problem with the cable connection or the TV/monitor/projector. Please check the "Trou-
bleshooting" section in such case.
If, after the initial screen (a "DUNE" logo) disappears, there is no other picture on the screen
in 10 sec and more, then it is most likely a problem of incorrect video mode set in the player.
Please address the "Quick Setting of Video Output Mode" section below in such case.
Connecting a TV/Monitor/Projector with
HDMI/DVI Input
Since the player is designed first of all for playback of high definition (HD) video (up to
1080p), the best way of signal transmission from the player to a TV/monitor/projector
is the HDMI interface. In this case, video and audio streams are transmitted in digital
form, without loss, delivering excellent picture and sound.
 If your TV/monitor/projector has no HDMI port but is equipped with the DVI one, you can
use an HDMI-DVI adapter (to be connected to HDMI-HDMI cable) or HDMI-DVI cable (no
adapter needed). In this case, transmission of audio stream via HDMI is not supported, so one
of the analog or digital audio outputs has to be used.
1. Make sure that the player and the TV/monitor/projector is switched off. Do not switch them
on until the connection procedure is finished.
2. Connect the HDMI/DVI cable and (if needed) the HDMI-DVI adapter.
3. Using RC/buttons of the TV/monitor/projector, select the required input port and (for display
mode. For further instructions please refer to the manual of your displaying equipment.
4. Power on the devices. Wait until the initial screen (a "DUNE" logo) is shown.
Connections
Chapter 3