User's Manual

Confidential Google Remote Control User Manual

8/5 0.1, RC1534059/01B

DRAFT

Feature

Key sequence

Learn

<<1+5>>, <learnable key>, <Exit>

Learnable key: TV_POWER, INPUT, VOL+, VOL-, MUTE, UP, LEFT, OK, RIGHT and DOWN.

The procedure is as following.

1. Press Digit 1 and Digit 5 simultaneously for 3 seconds. After 3 seconds the TV Power

key LED will blink twice and remain on. Release all keys.

2. Enter a learnable key, the TV Power key LED gives a short inverse blink. After the key

is released, the LED will start blinking.

3. Hold the source RC (in of sight) at an optimum distance (3cm to 6cm) and

continuously transmit the signal by pressing and holding the key from source RC that

you want to learn into the RC.

4. The LED gives 2 blinks and stays on if learning is successful and the new learnt codes

will replace the previous one. Release the key from the source RC.

The LED will give an error blink and stays on if the learning is failed. The previous key

code is kept.

5. User can learn other keys or retry learning on the same key by following step 2 to 5.

6. Press the <Exit> key to exit to the use-mode. After pressing the OK key, the LED will

turn off and return to use-mode.

Notes:

 If no key is pressed within 30s after enter into the learn setup mode, the RC will

return to use-mode with an error blink to indicate time out.

 If no signal for the RC to learn within 30s after pressing a learnable key, the RC will

return to use-mode with an error blink to indicate time out.

 If the learnable key has been pressed for 30s, the RC will enter into Stuck Key Time-

out.

4.6 Pairing with TV Box

BT Pairing of RC with TV Box will take place in following 3 situations:

 when RC and TV Box are out of the box and install for the 1

time

 when existing RC is lost or broken and a new replacement RC is added

 when TV Box is being replaced or reset, and added to work with existing RC

The RC interacts with the TV Box UI via IR, or BT.

By factory default or after a master reset, the RC does not contain any BT pairing information.

The RC will default to be in TV_BOX Mode. The RC will send TV_BOX IR Code.

In BT mode, the TV_BOX Power key will start to use RF until the BT link is disconnected (either

due to TV Box out of range or TV Box is off or TV Box is being replaced). BT pairing is described

in more detail at section BT Pairing.