Instructions

Documentation Testing Software (Status 28.09.2011)
HAZET
®
Torque-Tester 7901 E , 7902 E, 7903 E
Page 9 from 24
HAZET-WERK GmbH & Co. KG · Postfach 10 04 61 · D-42804 Remscheid · Germany
Telefon [phone] / 7 92-0 · Telefax +49 (0) 21 91 / 7 92-375 · www.hazet.com · [e-mail]
Measuring
If no check mark was put in the box <Save certificate
(auto.)>, the certificate can be saved manually by
clicking on the box <Save certificate>.
By clicking on the box <Print> you will be able to see a
print preview of the certificate. In the print preview you
can select the printer from the list <Printer> and start
printing by clicking on <Print>.
The Torque wrench should be recalibrated, if you reach
only out-of-range measurements in 10 successive
attempts. In case you need a proof for this, please click
<Save (Testvalue)> in order to create a report in PDF
format.
Note: To set a torque wrench, e.g. after repair works,
you will find out the relevant values from the smallest
test value in the table.
By clicking on the box <Stop measuring > you delete all
the values.