Instructions

Documentation Testing Software (Status 28.09.2011)
HAZET
®
Torque-Tester 7901 E , 7902 E, 7903 E
Page 15 from 24
HAZET-WERK GmbH & Co. KG · Postfach 10 04 61 · D-42804 Remscheid · Germany
Telefon [phone] / 7 92-0 · Telefax +49 (0) 21 91 / 7 92-375 · www.hazet.com · [e-mail]
Master data / Article test units
To enter the data of a new article test unit, select on the
select list <Master data> <Article test unit>.
By clicking on <New> you can enter the data of a new
article test unit. By clicking on <Edit> the data of an
article test unit will be changed. The entry boxes are
yellow.
Note: If you modify the data, the original data will get
lost. Please consider if you need the data of this article
test unit for future tests.
In the box <Number> you can enter the type designation
for the article number and in the box <Description> you
can enter the designation for an article test unit.
By clicking on <OK> you will confirm the entry.
Note: Mandatory fields left unfilled will be red once the
entry was confirmed by clicking on <OK>.
Master data / Measuring range
If a new torque wrench was „created“, it can be
necessary to establish a new measuring range. To
create a new measuring range, select on the select list
<Master data> <Measuring range>.
In the table the registered measuring ranges are
displayed. If the measuring range of a new torque
wrench has not yet been established, this range has to
be „created“.
Note: The test values of a new torque wrench must be in
the measuring range of the torque tester to use.
By clicking on <New> you can enter a new measuring
range. By clicking on <Edit> an established measuring
range can be modified. The entry boxes are yellow.
Note: If you modify the data, the original data will get
lost. Please consider if you need the data of this
measuring range for future tests.
Confirm by clicking on <OK>.
Note: Mandatory fields left unfilled will be red once the
entry was confirmed by clicking on <OK>.