User manual

ManualsBrandsHAZET ManualsCar ToolsHydraulic foot pump, mechanical, two-stage

1. Owner’s liability

• This tool was developed and manufactured accord-

ing to the applicable regulations and norms valid

at the time of its construction and is considered to

be operationally reliable. Nevertheless, the tool can

present a danger when it is not used as intended

or in an inappropriate way by non-qualiﬁed per

sonnel. All persons using this tool or carrying out

maintenance work theron must carefully read and

understand these operating instructions before

commencing work and are aware of how to handle

hydraulic components.

• Any modiﬁcation of the tool is strictly forbidden.

• All security advices, warning and operation notices

on the tool have to be kept legible. Immediately

replace all damaged labels or stickers.

• All indications concerning setting values and setting

ranges must be observed.

• Always keep the operating instructions close to

the device.

• Specialist technical knowledge and/or suitable

training is required for the use and repair of this

tool.

2. Intended use

Operational reliability is only guaranteed if

the device is used as intended in accordance with the

information in the operating instructions. In addition to

the safety advice in these operating instructions, the

general safety regulations, regulations for the preven

tion of accidents and regulations for environmental

protection valid for the application area of this tool

have to be observed and respected.

Always ensure that the use and maintenance of

the tool complies with relevant local and national

regulations.

• The tool must only be used if it is in good working

order. If the pump is jerky or noisy in operation, or

if oil leaks and/or damage is visible, the tool must

be taken out of service and checked.

• All safety equipment must always be within reach

and should be checked regularly.

• The HAZET two-stage foot pump 4932 N-100

serves to operate the HAZET hollow piston cyl

inder 4932-17. When operating other hydraulic

aggregates, the operating and safety instructions

supplied by the manufacturer of these aggregates

must be observed.

• The HAZET two-stage foot pump is designed for

a maximum operating pressure of 700 bar.

• The HAZET hydraulic pump must be operated on

ﬁrm ground and must not be inclined at more than

15°.

• It is essential that the hydraulic hose is of sufﬁcient

length.

• The bending radius of the hose must not be less

than 35 mm.

• Overloading can cause failure of the hydraulic

system and can hence cause damage to body,

health or property.

• Never exceed the maximum load.

• Incorrect use of the HAZET two-stage foot pump

or use whilst failing to comply with the safety in

structions can result in serious injury or death.

• Any other kind of use and/or use that goes beyond

the intended use of the device is prohibited and is

deemed to be improper.

• Any claims against the manufacturer and/or its

authorized agents because of damage caused by

improper use of the tool are void.

• Any personal injury or material losses caused by

improper use of the device are the sole responsi

bility of the owner.

2 For your safety