Installation Guide

USE ONLY HAYWARD GENUINE REPLACEMENT PARTS 4
GENERAL INFORMATION
The Hayward StarClear filter is a high performance swimming pool filter with a residential filtration rating of 1,500 gallons
(5.6 kl) per hour (Model C250), or 3,000 gallons (11.3 kl) per hour (Model C500). Manufactured from durable, corrosion-proof
materials, they are designed for continuous or intermittent operation, for installation above or below the pool water line, for
fresh or saltwater swimming pools or spas. StarClear filters utilize a reusable single element, reinforced polyester filter
cartridge to provide a high degree of water clarity with absolute minimum care. Their unique design is such that no tools are
needed to remove or replace the cartridge in the filter assembly. Simply spin off the locking knob, lift off the filter cover and
remove the cartridge. It's that easy.
PUMP SELECTION AND LOCATION
To power your StarClear filter, select a continuous duty pump designed for swimming pool or spa service.
It is important to first determine where your pump and filter will be located. If above the water line, a self-priming pump must
be used. Self-priming pumps such as Hayward's Super Pump
®
, Super II™, or TriStar™ have the ability to lift water
from a lower level and prime automatically.
Select a pump appropriate for your application. Take into consideration, operation of hydrotherapy fittings, automatic
cleaners, required turnover rates and losses in the system. A dealer can help you select the proper size pump for your system.
FILTER LOCATION
1. Since plumbing fittings offer a resistance to water flow, position the filter as close to the swimming pool as local codes
allow. Keep the number of fittings to a minimum. Select a well-drained area, one that will not flood when it rains.
2. Set the filter on a solid level surface. Allow a minimum top clearance for cartridge removal of 11" (280mm) for the C250 and
allow 31" (787mm) for the C500. Be sure filter, pump, drain & pressure gauge are accessible for convenient operation.
3. Position the filter so the tank can drain by gravity.
4. If practical, place pump and filter in the shade to shield it from continuous, direct heat from the sun.
PLUMBING
1. Use 1-1/2" piping or hoses joined with insert fittings and stainless steel clamps. When making permanent connections, be
sure to provide unions for easy servicing.
2. Refer to the diagrams on previous page for basic suggested valve installation. Ball valves are recommended where
needed. While systems vary, the main consideration is to provide the desired control of water flow from the pool to the
pump and filter, and back to the pool. When the filter is located below water level, provide valves to prevent back flow of
water to the filter during cleaning and routine servicing.
3. All plumbing on the StarClear filter is 1-1/2" female NPT. When making threaded connections to the filter use plastic
adapters. Apply three turns of TFE tape (or use special plastic pipe sealant) to male threads.
Screw the fitting into the thread hand tight; then using a wrench, tighten one more full turn. Additional tightening is
unnecessary and could result in broken or damaged fittings.
4. Connect the pool suction plumbing between the skimmer, pool outlet, etc. and the pump.
5. Install the pool return plumbing.
6. If the pressure gauge is not installed, apply three wraps of TFE tape to the gauge threads, and
carefully screw the gauge
into the threaded hole in the filter head.
7. A filter drain plug is furnished with each filter and is all that is needed for complete filter draining. A manual air relief valve
is furnished to aid in bleeding off unwanted air when starting the filter. The auto air relief provides air removal during
operation.
8. All electrical connections should be made in accordance with local codes.
9. Check for joint leaks before operating
10. Refer to pump instruction booklet for pump information.