Compatibility Chart

P A G E | 3
www.hayesindustrialsolutions.com | DIGITAL HEATING TOOL
USER’S MANUAL
Hayes Digital Socket Fusion Pipe Welder
(Before use, please read the manual carefully)
ABOUT THIS MANUAL
This manual is only a manufacturer´s guide. It does not take the place of proper training by qualified instructors and
does not exceed the experience of a professional. The information in this manual is operational and cannot cover all the
situations that may occur in the field such as environment temperature, pipe material, thickness, selected welding
standard, etc.
BEFORE THE WELDING PROCESS
A. Cut and chamfer the pipe.
B. Place the cold ring at the proper depth on the pipe as determined by the depth gauge.
C. Attach the coated heating faces to the heating tool when the tool is cold.
D. Connect to a 110V grounded power source only and begin operating the welding machine. Permit enough preheating
to stabilize the temperature.
MACHINE SET UP
• Push ON/OFF button to power unit up.
• Set the desired temperature by pressing the button and then using the “up/down arrow” buttons
to choose the proper temperature and then press button again to start the heating process.
• Red light displays when the unit is in process of heating up.
• Green light displays when the unit has reached the desired temperature.
WELDING PROCESS
Put the pipes and fittings into the heating faces, remove pipes and the fittings from the heating faces when they reach
the proper heating time. Connect the pipes and fittings together until the bead is formed.
NON-STICK COATING
Coated surfaces have been treated to reduce polymer adhesion. If the polymer adheres to the heating plate, lightly wipe
with a clean cotton cloth to remove. Do not use a wire brush or an abrasive.
WELDING PARAMETERS
Pipe and fitting manufacturers have established qualified fusion procedure which should be followed precisely. You
should obtain a copy of the pipe manufacturer's procedures or appropriate joining standard for the pipe being fused.
HEATER TEMPERATURE
To meet pipe manufacture’s temperature specifications, the surface temperature of the heating face should be
measured with a surface pyrometer prior to initial use and at reasonable time intervals thereafter.
Ensure you test the temperature on the surface of the heating face and not on the heating plate itself. The heater’s built-
in thermometer indicates internal temperature and should only be use for reference.