Owners manual

Controller Mounting and Installation
Controller and Mounting Bracket
• The bracket provided is to be used for mounting the controller to the tow vehicle.
• Use the reversible slotted bracket.
• Use only the provided screws to attach the bracket to the controller.
Installation Steps
1. Install the mounting bracket to a solid surface under the tow vehicle dash using the two
machine screws and fasteners provided. Tighten until snug. See Figure 2 – acceptable
mounting positions and Figure 3 – attachment of Mounting Bracket.
2. Insert four of the self tapping screws provided through the mounting bracket holes and into the
desired controller anchor holes. Tighten until snug.
3. Mount in a location which allows the driver to easily apply the manual override and see
the Red Indicator Light.
Tinnerman Nut
Self
Tapping
Screws
Pan Head
Machine
Screw
Mounting
Bracket
Fi
g
ure 3
–
attachment of Mountin
g
Bracket
WARNING:
• All four controller wires must be connected properly for the controller to operate
correctly.
• Failure to properly connect all four wires can cause loss of trailer braking.
• Improper wirin
g
will destro
y
the controller and void the manufacturer’s warrant
y
.
WARNING:
• Use of longer screws than those provided can damage the unit and cause loss of
braking.
CAUTION:
• Care must be taken to ensure that the mounting surface is rigid enough to prevent
excessive vibration.
• Excessive vibration may result in poor performance.
!
!
!