Other Content

71
COOLER ACCESSORIES
Technical Guide
COOLERS
205
211
214
291
2106
Designed to fit between the filter and the
block, these thermostatic adapters begin
directing oil to the cooler when the oil
temperature reaches 160°F and direct all
oil to the cooler when the temperature
reaches 180°F.
205 – Fits Ford, Chrysler and imports.
3/8” FPT ports with 3/4”-16 thread
mounting nut.
211 – Fits Chevrolet and GM with large
(3-1/2”) O-ring diameter. 1/2” FPT ports
with 13/16”-16 thread mounting nut.
225 – Fits AMC, Jeep, some GM with
small (2-3/4”) O-ring. 3/8” FPT ports with
13/16”-16 thread mounting nut.
242 – Fits 1976 and later GM. 3/8” FPT
ports with 18mm x 1.5 thread mounting
nut.
243 – Fits AMC and imports 3/8” FPT ports
with 20mm x 1.5 thread mounting nut.
Some O.E. filters may not seal, use FRAM
#PH3950 or equivalent.
The out port is on the left with O-ring side
up, facing ports. CAUTION: To avoid oil
pressure loss and possible engine damage,
do not use sandwich adapters to install
transmission coolers as engine oil coolers.
Thermostatic Sandwich Adapters
For use when relocation of the oil filter is
necessary, these mounting kits include all
hardware necessary except hoses.
214 – Fits Chevrolet and GM with large
(3-1/2”) O.D. O-ring.
291 – Universal remote filter mount, fits
small (2-3/4”) O.D. O-ring only. Includes
3/4”-16”, 13/16”-16, 18mm x 1.5, 20mm
x 1.5 adapters.
2106 – Compatible with engine oil or
transmission fluid. 3/8” FPT ports facing
forward. No block adapter included.
1 REMOTE FILTER MOUNTS HAVE 3/8”
FPT PORTS.
2 BLOCK OFF ADAPTERS HAVE 1/2” FPT
PORTS.
3 ALL FILTER MOUNTS USE FORD TYPE
FILTERS, SUCH AS FRAM PH8A OR
EQUIVALENT.
4 USE #112 HOSE FOR ENGINE
APPLICATIONS, #105 FOR
TRANSMISSION APPLICATIONS.
Remote Filter Mount Kits
(Non-Thermostatic)
Oil Thermostat
163
163 – Oil thermostat for use with engine
oil or transmission fluid begins closing
at 160°F, fully closed at 180°F, 3/8” FPT
fittings.