– INSTRUCTION MANUAL – PC PORTABLE DESIGN BY PIERRE CHARPIN
– GENERAL INFORMATION – TECHNICAL DATA To extend battery life, it is recommended to regularly charge it with the supplied USB cable. This product is fitted with a low voltage LED The battery in this lamp is non-replaceable. The (DC 3.7V) bulb fitting and supplied with a suitable battery must be removed from the lamp and LED bulb. HAY recommends using the supplied disposed of safely before the lamp is disposed of. bulb with this lamp.
CAUTION | Changes or modifications to this unit CARE AND MAINTENANCE not expressly approved by the party responsible for compliance could void the user’s authority to The product can be cleaned with a soft damp operate the equipment. This device complies with cloth and mild detergent, or a dry microfibre part 15 of the FCC Rules. Operation is subject to cloth. Do not use alcohol or any other solvents the following two conditions: to clean the product and avoid using abrasive or rough sponges.
– PARTS – Lamp LED Bulb USB Power Cable
1. Unpack all the parts and check that you have received all the parts listed. Remove the shade by turning it counterclockwise and then lifting it off the lamp base. 2. Locate the supplied bulb, remove it from its packaging and place it into the bulb fitting, located in the lamp base. For replacement bulb options, please refer to the HAY website.
3. Place the shade onto the lamp base, aligning the grooves on the shade with the bayonet fitting inside the lamp base. Turn clockwise and tighten securely.
4. To charge the battery, insert the USB charger into the USB port on the bottom of the lamp and connect the cable to a power supply. When the battery is charging, the light on the bottom will show red. When the battery is fully charged, the light will show green. The lamp can be used while charging, however this will extend the required charging time for full capacity.
5. To turn the lamp on, touch the round button on the bottom of the lamp. The lamp has a three-step dimmable feature. First push sets it to maximum brightness, second push to medium brightness and the third push to lowest brightness. Fourth push turns the lamp off. Please save these instructions for future reference.
– CARE & MAINTENANCE – Our Care & Maintenance offers guidance for optimal maintenance of your HAY product. It includes advice and instructions on cleaning and caring for specific materials to prolong the life of your lighting. Please find our Care & Maintenance guide by scanning the QR code You can find more relevant information on PC Portable by scanning the QR code You can also find the same information here hay.
Havnen 1 8700 Horsens Denmark +45 4282 0282 / hay@hay.com www.hay.
