User Guide

Enable Haxiot Cloud Service
Haxiot HXC900 Device Developer Kit Quick Setup Guide
Package includes
1 x Haxiot HXC Dev Shield w/ ST Nucleo
1 x USB Micro cable
1 x u.FL FPC antenna
1 x Quick start guide
1. Ensure you have activated your Haxiot X-ON
cloud account at https://signup.haxiot.com with
the included activation code
2. Ensure the Gateway is on & connected
Caution: The Haxiot HXG3000 Indoor Gateway is a radio transmitting device. This device is for indoor use only.
Regulatory Notices:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that may cause undesired operation.
© All rights reserved. Haxiot Inc. Website: www.haxiot.com Support: [e-mail]
Address: 2500 Dallas Parkway #535, Plano TX 75093, USA
1
3
Load scan.haxiot.com on your smartphone using
the assigned Haxiot X-ON username and
password.
Select the SCAN button to provision and test the
HXC Dev shield using the QR code label on the
device. Select “LoRaWAN Dev Kit App” in the drop
down.
The LED turns Purple when connected.
For detailed user manual, please download the HXG3000 user
manual from the Haxiot support site: support.haxiot.com, or contact
4
Provisioning Device
The HXC Dev shield should be pre-installed on the
ST Nucleo board with the u.FL antenna
Connect the included USB micro cable from the
Nucleo to a USB port or battery
IMPORTANT: The Gateway must be provisioned &
activated before the Device Developer kit is
activated
2
Setup & Connect
Unpack Haxiot Device Developer Kit