Specification Sheet

APPROVED:
DRAWN:
PART NUMBER
SCALE:
SHEET OF
REVISION
DRAWING TYPE: SIZE: A
BY:ECN NO.
DATE:
DATE:
ECN:
REVISED PER
CHK'D.:
Haws Corporation - All Rights Reserved.
HAWS and other trademarks used in these materials are the exclusive property of Haws Corporation.
C
R
MODEL(S)
1455 KLEPPE LANE
SPARKS, NEVADA 89431
[phone] FAX [phone]
E-MAIL: [e-mail]
WEBSITE: WWW.HAWSCO.COM
THIS DOCUMENT IS TRUE AND CORRECT AT TIME OF PUBLICATION. CONTINUED PRODUCT IMPROVEMENTS
MAKE SPECIFICATIONS AND MEASUREMENTS SUBJECT TO CHANGE WITHOUT NOTICE.
MJ 06/30/16
14
0002080045.D
PORTABLE EYEWASH
7501/7501T/7501T240
1:1
22
FV 07/12/16
5086
VWC
INSTALLATION
5086
2016
54 1/2" TO 66 1/2"
[1384mm TO 1689mm]
TO FINISHED FLOOR
33" TO 45"
838mm TO 1143mm
TO FINISHED FLOOR
FLOOR
LINE
STAND BY
"OFF"
POSITION
ACTIVE
"ON"
POSITION
DO NOT EXCEED WATER FILL
LINE. REFER TO INSTALLATION
INSTRUCTIONS IN "OPERATION AND
MAINTENANCE MANUAL" FOR
PROPER FILLING PROCEDURES.
NOTES:
1. TO COMPLY WITH ANSI Z358.1-2009 FOR EMERGENCY EYEWASH OR EYE/FACE WASH AND
SHOWER EQUIPMENT:
- UNIT SHALL BE INSTALLED IN ACCORDANCE WITH MANUFACTURE'S INSTRUCTIONS AND
ACCEPTABLE PLUMBING PRACTICES.
- EYEWASH OR EYE/FACE WASH SHALL BE POSITIONED WITH NOZZLES NOT LESS THEN
83.3 CM (33 IN.) AND NO GREATER THAN 114.3 CM (45 IN.) FROM SURFACE ON WHICH USER
STANDS AND 15.3 CM (6 IN.) MINIMUM FROM WALL OR NEAREST OBSTRUCTION.
2. UNIT MUST BE LEVEL FROM FRONT TO BACK AND SIDE TO SIDE.
3 ALL THREE MOUNTING HOLES ON MOUNTING-BRACKET MUST BE USED TO PROPERLY
SECURE EYEWASH UNIT TO WALL.
4 LOCATE ONE 1/2" THICK SPACER (QTY. 3 SUPPLIED) BEHIND EACH HOLE IN THE MOUNTING
BRACKET AS SHOWN.
5. * DIMENSIONS MAY VARY ±1/2" [12.7mm].
6.
(NOTES CONTINUED ON SHEET 3 OF 3)
3 3X 1/4" MOUNTING
HARDWARE
(NOT SUPPLIED)
3X
Ø 5/16" 3
Ø [8mm]
MOUNTING
BRACKET
(SUPPLIED)
MODEL 7501T/7501T240 - WITH HEATED JACKET
(SHOWN)
1/2" THICK
SPACERS
4
MODEL 7501 (SEE SHEET 1 OF 2)
** GFCI 8' POWER
CORD (120VAC,
60Hz, 200W)
(7501T ONLY)
OVER-TEMP
THERMOSTAT
* 18"
[457mm]
* 12-1/2"
[318mm]
* 21-1/2"
[546mm]
1 1/8"
[29mm]
2 1/4"
[57mm]
* 24"
[610mm]
* 8"
[203mm]
1 1/4"
[32mm]
* 15-3/4"
[400mm]
* 22"
[559mm]