ny) ® INSTALLATION, OPERATION ¢ / Fae & MAINTENANCE INSTRUCTIONS 1455 Pepper Lane «Sparks, NV 89431-6467 +(775) 369-4712 «Fax (775) 359-7424 E-mail: + website: www.hawsco.com No. 2080058(17) Model 7500 Portable Eyewash NOTE TO INSTALLER: Please leave this information with the Maintenance Department. LIMITED WARRANTY HAWS warrants that this specific product is guaranteed against defective material or poor workmanship for a period of one year from date of shipment.
RECOMMENDED TOOLS: Three 1/4" diameter anchors suitable for supporting filled eyewash (approximately 140 pounds) and tools needed to install these anchors. LOCATION OF UNIT: The Model 7500 Portable Eyewash should be installed in close proximity to potential accident areas. It should be clearly identified, free from obstructions and easily accessible, May be wall or shelf mounted.
MAINTENANCE INSTRUCTIONS NOTE: Customer must provide an inspection tag and maintain a record of inspection dates and type of maintenance performed (i.e. adding Sterile Antimicrobial Preservative Model 9082, etc.) STEP 1; Self contained eyewash equipment shall be visually checked to determine if flushing fluid needs to be changed or supplemented, See STEP 3 for additional information regarding activated units.
TROUBLESHOOTING PROBLEM REPAIR CHECKLIST No flow. Tank empty. Refill tank. Obstruction in line or fitting. Clear obstruction. Poor flow from eyewash head(s). Tighten head assembly, Check for obstructions. If necessary, remove eyewash head(s), clean and reassemble. To reassemble head, place cap screw through head and thread into head anchor two or three turns. Tilt head assembly and work anchor legs into eyewash armholes. Tighten assembly. Check for leaks. Water leak between joints or fittings.
108 CENTERFOLD 15 TARE 36) CORRECT AT TIRE GF PUBLICATION, CONTINUED PRODUCT PREVENTS HE SPECIFICATIONS AND HEARTSICKNESS SUBJECT TO CHANGE WITHOUT NOTICE ITEM DESCRIPTION PART NO. 1 |EYEWASH HEAD ASSEMBLY SP 2 |BRACKET 0001217418 3 |CAP SP131 4 | STERILE ANTIMICROBIAL PRESERVATIVE |9082 PARTS BREAKDOWN STAND BY 3 "OFF" ° 8 POSITION ant + A ACTIVE "ON" POSITION {NOT SUPPLIED, MUST BE ORDERED SEPARATELY) AEE PEPPER LANE @ SPARKS, NEVADA 83431 (775) 860.4712 FAX (756) 350.
7H DOCUMENT 15 TRUE 503 CORRECT 7 TIE OF PUBLICATION, COM TINGED PROCTOR IMPROVEMENTS HAE SPECIFICATIONS AND MEASUREMENTS SUBJECT TC CHARGE WITHOUT NOTICE 1-178" 29mm 3X 2-144 1/4" MOUNTING HARDWARE [3] Blammo (NOT SUPPLIED) MOUNTING STAND BY sna BRACKET "OFF" POSITION xo BE (SUPPLIED) 1-31 A Ary 45mm } Tl 587mm ACTIVE "ON" 22-112 I POSITION 572mm ! “3104 83mm 52-718" TO 1343mm TO 1848mm TO FINISHED FLOOR 33 TO 48" «ati 838mm TO 1143mm ser 3 TO FINISHED FLOOR 495mm 548mm Lo NOTES: 1.
