Dimensional Drawing

08/17 Model 2000S/2000SN Page 4 of 6
Step 5: Create a wall opening for the unit as shown in Step 5 Diagram – hold rough-in dimensions to
within 1/8”. The bottle filler is designed to fit between two normally spaced 2 X 4 studs (16”
center-to-center).
Install waste line, supply line, and electrical lines in locations shown. The supply line should
be brought up through the rectangular waste cutout in the bottom of the unit. Double-check
waste, supply, and electrical line locations.
Install a 1/2” IPS supply screwdriver stop (not supplied) into the water supply line where it will
be readily accessible.
NOTE: A suitable trap must be used in conjunction with the waste. This trap should be
positioned in a location where it can be accessed and removed (it may be helpful to use a
wall-mounted access panel).
NOTE: When installing this unit, all pertinent local, state, or federal codes should be adhered
to.
Bottle filler (rear cover removed) viewed from behind wall
Step 5 Diagram