Manualshelf

Owners manual

ManualsBrandsHawking Technology ManualsComputers & LaptopsHigh Power Outdoor Wi-Fi Access Point, Bridge with built-in AP Controller and PoE included (HPOW5CM)
11121314151617181920
13
Chapter II: System and Network Setup
2-1 Build Network Connection
Please follow the following instructions to build the network connection between your new HPOW5CM
access point and your computers and other network devices:
1. Remove cover from device. Press the center tab (you may need a flathead screwdriver) and the
cover should be able to be removed with a small amount of force.
2. Connect the A/C power adapter to the wall socket, and then connect it to the ‘Power’ socket of the
PoE injector. Connect a Ethernet cable from the “P + Data Out” port on the PoE injector into the
HPOW5CM LAN1(POE) Port.
3. Connect a Ethernet cable from the “10/100 Data in” on the PoE injector to your computer/network.