User Manual

Key Length: There are two types of WEP key length: 64-bit and 128-bit. Using ‘128-bit’ is safer than
’64-bit’, but will reduce some data transfer performance.
WEP Auth Method: Open system - there is no authentication to access AP or wireless NIC
Shared - only those with the same key with the AP can connect to it.
Key Index: You can set up to four sets of WEP key, and you can decide which key is being used by
default here. If you don’t know which one you should use, select ‘Key 1’.
WEP Key 1-4: You can chose either HEX or ASCII for your WEP key value, for 64bit encryption strength
can use 10 digits for HEX (0~9, a~f and A-F) or 5 digits for ASCII (0~9, a~z and A~Z), for
128bit encryption strength can use 26 digits for HEX (0~9, a~f and A-F) or 13 digits for
ASCII (0~9, a~z and A~Z), for 152bit encryption strength can use 32 digits for HEX (0~9,
a~f and A-F) or 16 digits for ASCII (0~9, a~z and A~Z)
3-3-4-2-3 AES
When you select this mode, the wireless access point will use WPA encryption, and the following setup menu will
be shown on your web browser:
AES is short for Advanced Encryption Standard, The AES cipher is specified as a number of repetitions of
transformation rounds that convert the input plain text into the final output of ciphertext. Each round consists of
several processing steps, including one that depends on the encryption key. A set of reverse rounds are applied to
transform ciphertext back into the original plaintext using the same encryption key.
AES Key Enter the information for pre-shared key; the format of the information shall according
to the key type selected. Pre-shared key can be either entered as a 256-bit secret in 64
HEX digits format, or 8 to 63 ASCII characters
Click Finish and the device will automatically restart and save your settings. After you have finished, at least one of
the WDS devices must be connected to your network via the 10/100 Data In port on the PoE adapter or the LAN2
port to add this WDS device to your network. The other WDS peers just need to be powered on via the P-Data Out
port on the PoE adapter and can be stand alone. Please change your computer IP address back to “Obtain an IP
automatically”.