User Manual

Extension Channel: Only for Channel Bandwidth 20/40. Select the desired channel bonding for control
ESSID: This is the wireless broadcast name. By default, it is ‘Hawking_Outdoor’ but you can
change it to whatever you want.
3-3-4 WDS Setup/Wireless Security
3-3-4-1 WDS Setup
This page allows you to setup the WDS Link. Enter the Remote WDS peer’s MAC Address and select an appropriate
security type for WDS Link. Note that the remote WDS peer should also be using this device’s MAC address.
Reference Status, Overview to get the wireless MAC Address.
Service: Enable/disable to turn on/off WDS mode
WDS Peer’s MAC Address: Enter the MAC address of the WDS Peer (aa.bb.cc.dd.ee.ff)
3-3-4-2 Wireless Security
This page allows you to set up wireless security to prevent any unauthorized access to your wireless network.
Next to security type, choose your type of security (Hawking recommends WPA-2PSK)
3-3-4-2-1 Disable wireless security
When you select this mode, data encryption is disabled, and every wireless device in proximity will be able to
connect your wireless access point if no other security measure is enabled
Use this option only when you want to allow any user to use your wireless access point, and you are not
concerned about unauthorized access to your files and/or transfers over your network.
3-3-4-2-2 WEP - Wired Equivalent Privacy
When you select this mode, the wireless access point will use WEP encryption, and the following setup menu will
be shown on your web browser: