User Manual

Choose Router AP Mode and click save & reboot. The device will now reboot. After the device has finished
rebooting, you will have to make changes to your computer’s physical connection. See below.
The physical setup is slightly different than the standard setup. Plug your computer into LAN2 on the access point.
Plug your ISP’s modem into the PoE ‘10/100 data in’ port.
Now, open your browser and go to 192.168.2.254. It should take you back into the settings page. Go to system
and select “Setup Wizard”. Click “Next”
3-1-1 Internet Connection Type
Choose your mode. Most ISPs use “Dynamic IP”. If you are unsure, please contact your ISP. Refer to Section 4-1
for a more in-depth explanation of these settings.
3-1-2 DNS
Choose your DNS type. By default, it will be received automatically but if you have a preferred DNS or you have to
specify one, please choose “specify” and enter in your values.