User Manual

When CPE + Repeater AP Mode is chosen, the system can be configured in Wireless repeater mode. In this mode,
the device can wirelessly connect to a WISP (wireless internet service provider), ie. Another wireless AP, HotSpot,
etc. It can then wirelessly repeat the signal and can even act as a router for these signals. NAT is enabled and
wired and wireless computers can share the same IP range. Go to section 3-5
2-3 Connecting to the HPOW5/HPOW10D via Web Browser
After the network connection is built, the next step you should do is setup the access point with proper network
parameters, so it can work properly in your network environment.
Before you can connect to the access point and start configuration procedures, your computer must be set to
static IP. Please follow the following instructions to configure your computer to use a static IP address:
If the operating system of your computer is….
Windows XP - please go to section 2-3-1
Windows Vista/7 - please go to section 2-3-2
Mac OS - please go to section 2-3-3
2-3-1 Windows XP IP address setup