User's Manual
17
PARAMETER
DESCRIPTION
A
Refresh - Refresh the list of adapters on your computer: “B“ block
Mode - There are two modes: Station and Access Point. If “Station" is selected,
the adapter works as a standard wireless adapter. If “Access Point" is selected,
the adapter will works as a wireless AP.
View – Allows for viewing of specific items with your adapter such as the
current status.
About - To check the version of the software utility, select this item.
B
This is a list for you to configure several adapters in your PC from the utility.
C
Utility and Configuration tabs for the HWDN3 Adapters: General, Profiles,
Available Network, Status, Statistics, and Wi-Fi Protected Setup. The
following section will go over each tab in details
D
Show Tray Icon – To show the icon in the system tray, select the item.
Disable Adapter – This function is for you to disable or enable the adapter.
Windows Zero Config – To configure the adapter from Windows XP Zero
Configuration, check the item. (Recommended for Vista and Windows 7)
Radio Off – This function is for you to turn off or turn on the radio in the
adapter. If the radio is turned off, the adapter will not work.