User's Manual

47
13.9 - Exiting Cell Link
There are two methods by which you can exit the Cell-Link application.
1) From any screen or menu the application will exit if the red “hang-up” or “End” button is
pressed.
2) From the Main Menu, there is ‘Soft Key’ option for the “EXIT” function. Pressing the ‘Soft
Key’ associated with this function will exit the application. The Cell-Link application will also
close if you receive a phone call while using Cell-Link.
13.10 - Customer Support
Network Outages: Cellular networks occasionally experience periods of ‘service outage’ or
abnormally high amounts of traffic that hinders the ability to send data over periods of time.
Because your Cell-Link system utilizes these cellular networks, in rare occasions it may not be
able to send commands to your HomeRemote system due to cellular network outages or busy
network traffic. The Cell-Link system is designed to minimize these instances, and will ‘try’
three times to send your command if for some reason it cannot contact your HomeRemote
system. In the case of three consecutive failed attempts to contact your HomeRemote system, the
Cell-Link system will notify you that your command was unsuccessful. There will be a delay in
the response from when you push the Select button and when the response is received as the
service attempts to connect to your HomeRemote System.
Customer Support: The customer portal should be able to walk you through any difficulties
with downloading the application to your phone and activation. For further assistance, please
contact Hawking Technology Tech Support at 1.888.202.3344.
14 - HomeRemote Accessories (Compatible Z-Wave Devices)
The HomeRemote Wireless Home Automation System from Hawking Technologies is
compatible with any Z-Wave enabled wireless home control, home automation device, sensor or
module. There are hundreds of accessories from many manufacturers in the market to expand
your HomeRemote solution with. This section of the manual will guide you through a few of
these product categories and products. Installation of these accessories will vary from one
manufacturer to another, however there will always be a ‘Program’ or ‘Discovery’ button for
each of these devices. This button is used to ‘Include’ the Z-Wave enabled device into your
network. For more information on any of the products and categories listed below, please visit
the HomeRemote website at www.homeremote.net
.
14.1 - Lighting
Wireless Light Switches – Z-Wave enabled Wireless Light Switches replace your current
indoor light switches to allow for control of pre-wired lights within your home. These high