User's Manual

30
12.5.2 - Creating Rooms / Areas
The Setup Wizard will guide you through
the initial setup of your home and rooms,
however if you wish to make any changes
to your initial configuration you may do
so here.
To add a new room type the name of your
room in the box and select the section of
your home the room is in. Then click
Add.
To remove a room, click the Remove button next to the room you wish to remove.
Note: If you remove a room that devices are currently listed under, you will need to assign the
devices to another room in order to continue using them.
12.5.3 - Add / Edit or Remove Devices
The Add/Edit or Remove Devices page gives you information on all devices currently within
your system. This page allows you to change the name of your current devices as well as
remove devices that are no longer used. You can edit the name and location of any device any
time.
Expanding your System with new devices
The Setup Wizard will guide you through the initial setup of your new devices, however in the
case that you add new devices to your system at a later time you will need to use this page to do
so. When adding additional devices to your system you will first need to Include them into your
Handheld Remote Control. If you do not know how to do this, see the section in the manual that
goes over Adding Devices using your Remote Control.
After you have added the new devices into your remote control, place the Handheld Remote
Control physically next to the Gateway. On the remote control press and hold the Include button
until the Red and Green LEDs begin to flash simultaneously. Next press the Channel 1 ON
button on the Remote Control and the Green LED should begin to blink.
On the Adding Devices page scroll to the bottom and click Detect Remote while the Green LED
on the Remote Control is still blinking. You will have to do this rather fast to ensure a
connection. The interface should give you the status of the transfer. If the transfer fails try these
steps again.